Assembly

Remove packing material

Rotate stem (attached to bicycle) vertical

Insert handlebar side of stem into stem

 

Pedal Installation

⚠️ Pedals are side specific, see axle for designation

Add grease to both pedal threads with included grease pack

Attach left pedal to left crank and rotate counter clockwise with included pedal wrench

Attach right pedal to right crank and rotate clockwise with included pedal wrench

⚠️ Both pedals tighten by rotating towards the front of the bicycle

⚠️ Please do NOT use pedal washers when installing pedals.  Pedal washers provide minimal benefit, and if not installed correctly will cause damage to your crankset and bicycle. Some bikes need them and some do not.  Your bikes do not need them so please do not use them.

⚠️ It is best to re-tighten the pedals after 2-3 rides when new

 

Basket Installation

Please go to the following page: Basket Install

 

VeeGo Fat Tire Operation

Battery

Your battery has 3 positions: Unlocked, Locked, and Locked & On. It can be charged in all 3 positions.

Unlocked: Your battery can be inserted and removed.

Locked: Your battery is locked to the bike, the key can be removed, but the bike cannot be powered on.

Locked & On: Your battery is locked to the bike and it can be powered up.

⚠️ Do NOT transport your bike with the battery unlocked, it can slide up and down damaging the pins on the bottom side.

⚠️ If your key will not turn into the 'On' position, check lock pin at the back of the battery.

⚠️ Only use the included charger to charge your battery

LCD Buttons

Top '+" Button:

Press to increase pedal assistance level

 Middle 'Power' Button

Hold to turn bike on and off

Press to turn lights on/off

 Bottom '-' Button

Press to decrease pedal assistance level

Hold for Walk Mode

Middle 'Set' Button

Hold to enter settings menu

  

LCD Screens

 

BMS: Battery Voltage & Charge Level

Speed: Speed you are traveling at

PAS: Pedal Assistance Level (1-9)

Mode: Power Mode (not used)

 

Ride Info

Press 'Set' to cycle through info

TRIP1: Trip distance (accumulates until reset)

TRIP2: Trip distance (since bike powered on)

RUN TM: How long the bicycle has been operating for the current ride

ODO: Odometer

 

Trip1 Distance Reset

Hold 'Set' button to enter settings menu

Set1: Press '-' to reset trip distance

Hold 'Set' to exit settings menu

 

USB Charging

A USB charging port is located on the back side of your LCD button panel.

 

Charging Instructions

Charging Tips

Do not let battery go more than 3-4 months without a charge

 

Suspension Adjustment

Suspension Stiffness

Folding your VeeGo Fat Tire

 

Operating Specifications